Paver Cleaning & Sealing in Brevard County

What sealing actually does for you

• Enhanced color — restores vibrancy and gives pavers a rich "wet look" or a natural matte finish, whichever you prefer.
• Weed & moss prevention — joint stabilization helps lock the sand in place and cuts down the weed growth between pavers.
• Stain resistance — protects against oil, grease, rust and food spills, so what lands on the surface wipes off instead of soaking in.

Four steps, in this order

• Clean. Surface clean the pavers and remove the organic growth, staining and old failed sealer.
• Re-sand. Sweep fresh polymeric sand into every joint. This is the step most often skipped, and it is the one doing the structural work.
• Seal. Apply the sealer evenly and let it soak in rather than pool on the surface.
• Cure. Stay off it while it sets — typically 24 hours for foot traffic and 48 for vehicles.

The joint sand is the whole point

Pavers do not sit on a solid slab. They interlock, and what holds that interlock together is the sand between them. Once rain and pressure washing have flushed that sand out, individual pavers start to shift, edges get chipped where they knock against each other, and the surface goes uneven underfoot.

Weeds and ants are the visible symptom of the same problem — both are colonising a joint that has lost its sand. Polymeric sand sets firm when it is wetted in, and the sealer then locks the whole thing down. That is why a proper seal job stops the weeds coming back rather than just killing the ones that are there.

When to reseal

In Florida sun, expect roughly three to five years from a seal before it is ready for another coat — sooner on a driveway carrying daily vehicle traffic, longer on a shaded patio. The tell is water: on a sealed surface it beads, and when it starts soaking straight in instead, the sealer has worn through.